Talking about the Eight Steps and Methods of Weakly Buried Electric Wires

In addition to the power cords of home appliances, in order to avoid staggering of wires in the interior like the disk holes, weak wires such as telephone lines, network cables, and television signal lines need to be buried. Ding Sanbao, manager of Kuda's Decoration Engineering Department, detailed the steps for the buried burial of weak wires.

1

Determine the location of the weak-wire indoor access point. In this link, the owner needs to inform the designer of his own habits and functional requirements. For example, if TV is installed in the bedroom, the TV signal line interface must be installed on the bedroom wall; if the computer is used in the study, it needs to be in the study room. The network interface is installed on the wall; installing a telephone in the bathroom requires that the access point of the telephone line be led to the wall of the bathroom.

2

Lines. The line of bullets is a line that is stained with ink, and it is used on the ground or on the wall. The role is to determine the position of the weak wire from the weak box to the access point and provide reference for the late buried wire.

3

Shaving. According to the path of the route, the trunking used for burying the line pipe is artificially excavated on the wall. It should be noted that the steel bars in the wall must not be damaged during the shaving.

4

Embedded pipelines. During the process of burying the buried wire, it is forbidden to bury the bare wire directly in the wall. Therefore, the wire tube is required. The line pipe usually used for buried lines is divided into two types: PVC line pipe and galvanized iron line.

5

Start threading. Will be buried in the TV signal line, telephone line, cable, etc. from the weak box to the line pipe, through the line tube, until the final wall interface.

6

Check whether the line is open. After threading is completed, you need to use a multimeter and other devices to check the wires you are wearing, and check whether the circuit is smooth, whether there is a breakpoint or a short circuit.

7

After the completion of the overall renovation project, install the appropriate panel on the weak wire interface on the wall.

Covering the project. After the tube is buried and the threading is completed, the shaving tank needs to be covered. For example, for the wall shaving tank, the groove needs to be closed by caulking plaster, and then the sealing groove is fastened with the caulking tape, and then the wall decoration is performed later. For ground shaving, cement mortar is used to fill and level the tank, followed by normal floor or floor tiles.

8

After completing the above eight steps, the owner can set up corresponding businesses in cable television companies, network communications companies, telephone stations and other departments, connect corresponding signals, and install corresponding equipment for use.