Rapid design of low power switching power supply

Probe domestic switch needle KG-300K needle head diameter is 3.0mm normally open switch needle

High-power led lamp beads 1W white light Sanan 30mil high power LED lamp beads imitation lumens

Shunluo Inductance Power Inductor SWPA Series First Class Agent

0805RGB flashing

MOS power IC full range

Overview:
This paper introduces the basic principle of the switching power supply, and the structure of the Topswitch II type switching chip. It discusses the selection of the switching tube and the calculation of the main component parameters based on the design process of the small power universal switching power supply. Finally, through the simulation test, the design process of the power supply was certified.

0 Introduction DC regulated power supply is an important part of modern power electronic systems. A good DC power supply system is an important guarantee for high quality modern electronic systems. Switching power supplies have a wide variety of design methods and complex and diverse methods. Therefore, it is necessary to study a simple method to quickly design the general-purpose high-efficiency, low-cost switching power supply.

1 Switching Power Supply Working Principle Switching DC regulated power supply is formed based on the average value of the square wave voltage and its duty ratio and the integral characteristics of the inductor and capacitor circuits. The basic working principle is that the input AC voltage is first rectified to form a pulsating DC voltage, which is transformed by a DC-DC conversion circuit, and then a high-frequency alternating current of different pulse width is formed by the chopper circuit, and then the rectification and filtering output thereof is required. Voltage and current waveforms. If the output voltage waveform deviates from the required value, a current or voltage sampling circuit performs sampling feedback. After comparing the voltage value with the comparison circuit, the difference signal is amplified to control the pulse frequency f and the duty ratio D of the switching circuit. In order to control the conduction state of the output. Therefore, the output voltage and current can be obtained at the output.
As shown in Figure 1, the switching power supply module is divided into the following sections.

According to the actual needs of the power system, by analyzing each part, the corresponding switching power supply products can be designed.

Figure 1 is a block diagram of the switching power supply.

(Please read the PDF for details)