Electric iron heating wire breaking repair method

Electric iron heating wire break Here are two treatment methods. The simple repair method is to splicing the fracture. The quick and reliable treatment method is to take the heating wire out of the cylinder, first remove the oxide near the fracture, and then tightly Spliced.

A common fault in soldering irons is the breaking of the heating wire.

First, the simple repair method: the joint is spliced, but after this connection, the spark is often caused by the loose contact, and the joint is broken after a short time.

Second, the quick repair method: remove the heating wire from the cylinder, first remove the oxide near the fracture, and then splicing tightly, after splicing, sprinkle a little mixed powder of glass and electric ceramic around the joint (put the two according to 6 : 1 Grinding), after installation, the power is melted for a few minutes, and the powder adheres to the joint. In this way, the joint will not spark and it will be more durable.

There is a quick and reliable repair method: remove the heating wire from the cylinder, first remove the oxide near the fracture, and then splicing tightly. After splicing, sprinkle a small mixture of glass and electric porcelain around the joint (both Grinded at 6:1), after being installed, it is energized for a few minutes, and the powder melts and adheres to the joint. In this way, the joint will not spark and it will be more durable.